How to Replace La-Z-Boy Recliner Toggle Brackets with Stronger Aluminum Parts
La-Z-Boy recliner mechanisms have several small brackets and levers that can break under too much force or tension. We've created aluminum replicas of these pieces that are quite a bit stronger. If it broke once, replace it with something stronger.
Before You Start: Put the Chair on Its Side
Put the chair on its side. You're dealing with a lot of pieces, and if the chair is on its front and opens, or there's tension against it, you can break pieces. On its side is the easiest way to work.
The Brackets We Replace
Main bracket
Our aluminum piece is a replica of the original and fits right in, but it's stronger.
Lever piece
This piece breaks quite a bit. The aluminum replacement mounts on the double posts on the side, in two pin spots.
Square-bar bracket
The original is difficult to replace because a whole bar runs through it, and that means multiple screws and bolts. Our version does the same job but has two screws you can take off. Remove the old (probably already broken) piece, set ours in place, and screw it on. It's a much simpler install.
Toggle piece
This one breaks less often but can. It's easier to get to: a couple of bolts and clevis pins. Note the grease, which keeps the pieces moving easily.
Frequently Asked Questions
Why do La-Z-Boy toggle brackets break?
Usually too much force or tension on the mechanism.
Should I work on the recliner on its front or its side?
On its side. On its front, the mechanism can open under tension and break pieces.
Shop La-Z-Boy toggle brackets and all La-Z-Boy replacement parts.
Leave a comment